Graphtec 1.5mm blade holder for CB15 series blades (PHP35-CB15-HS) refurbished VinylMaster Cut Contour Cut Software

VinylMaster Cut Contour Cut Software (for PC users)

No need to outsource with high-speed quality up to 6

5mm posterboard

This is the original Roland part (number 1000004583)

1-inch (135 cm) (Extended Mode: width of the material) CUT SPEED All S2 models cut at speeds up to 56 inches (1414 mm) per second diagonal AXIAL ACCELERATION Up to 4 G MAXIMUM ACCELERATION Up to 5

Graphtec 1.5mm blade holder for CB15 series blades (PHP35-CB15-HS) refurbished VinylMaster Cut Contour Cut SoftwareCompatible with blades: CB15U, CB15U 2SP, CB15U 5SP, CB15U K30*, CB15UA, CB15U K20 2SP, CB15UA K30. 1. 5mm*** Blade holder with Red Top, and Brass Tip For CB15 Blades. These brass tip blade holders plungers are more rigid and lend to more accurate cutting. NOTE: REMOVE CB15 SP Blade spring before installing into this Blade holder. DO NOT install any blade spring. These brass tip bladeholders plungers are more rigid and lend to more accurate cutting.